User Contributed                                           MET/CAL PROCEDURE
=============================================================================
INSTRUMENT:            HP 5315A SUB PROCEDURE 1
DATE:                  23-Oct-97
AUTHOR:                User Contributed
REVISION:              0
ADJUSTMENT THRESHOLD:  70%
NUMBER OF TESTS:       3
NUMBER OF LINES:       56
CONFIGURATION:         HP 3325B
STANDARD:              Stanford Research FS700
=============================================================================
 STEP    FSC    RANGE NOMINAL        TOLERANCE     MOD1        MOD2  3  4 CON
  1.001  ASK-                        P                            F
  1.002  ASK+                                          X
  1.003  DISP         Allow the UUT a 1 hour warm-up.
  1.004  HEAD         {* FREQUENCY ACCURACY TEST *}
  1.005  DISP         Set UUT front panel controls as follows:
  1.005  DISP
  1.005  DISP         FUNCTION SELECT switch .............. FREQ C/GATE TIME
  1.005  DISP         FUNCTION SET (Blue shift key) ....... IN
  1.005  DISP         GATE TIME/DELAY control ............. Adjust
  1.005  DISP         CHANNELS A&B:
  1.005  DISP         TRIG LVL/SENS controls .............. MAX (CW)
  1.005  DISP         TRIGGER LEVEL/SENSITIVITY ........... SENS (IN)
  1.006  DISP         Set UUT front panel controls as follows:
  1.006  DISP
  1.006  DISP         CHANNELS A&B:
  1.006  DISP         SLOPES .............................. POS (OUT)
  1.006  DISP         AC/DC ................................ DC (IN)
  1.006  DISP         ATTN x1/x20 .......................... x1 (OUT)
  1.006  DISP         FILTER NORM/100 kHz .................. FILTER NORM (OUT)
  1.006  DISP         SEP/COM A ............................ SEP (OUT)
  1.007  DISP         Adjust GATE TIME control for a
  1.007  DISP         UUT reading of 1.00 S ± .05 S.
  1.008  DISP         Set UUT front panel controls as follows:
  1.008  DISP
  1.008  DISP         FUNCTION SELECT switch .............. FREQ A/PER A
  1.008  DISP         FUNCTION SET (Blue shift key) ....... OUT
  1.009  DISP         Connect the 3325A output to the UUT INPUT A
  1.009  DISP         through a 50 ohm feedthrough.
  1.010  STD          Stanford Research FS700
  1.011  JMP          2.001
  1.012  EVAL
  2.001  IEEE         [@3325] FU 1; AM 1 VR; FR 10 MH
  2.002  MEMI         Use keyboard to enter actual UUT reading in MHz.
  2.003  ACC          10.000000MH    0.0000009U
  2.004  MEME
  2.005  MEMC         MH             0.000046U
#!          Test Tol 4.6e-005, Sys Tol 9e-007, TUR 51.111 (>= 4.00).
  3.001  END
#! T.U.R.s less than 4.00:                  0
#! T.U.R.s estimated using RANGE value:     0
#! T.U.R.s not calculated (ASK- U):         0
#! T.U.R.s not computable at compile time:  0
#! FOR JUSTIFICATION REFER TO COMMENTS FOLLOWING EACH TEST IN THIS LISTING.